Rackmount VA 2000 Guide de l'utilisateur télécharger pdf (Page 55)

OPERATION

Eaton

9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 2

UPS Shutdown

To shut down the UPS:

1. Press the

button on the front panel for three seconds.

The UPS starts to beep and shows a status of “UPS off pending...”.

The UPS then transfers to Standby mode, and the

indicator

turns off.

NOTE Releasing the button before three seconds returns the UPS to its original

operating mode.

2. Switch off utility power where the UPS is connected.

Transferring the UPS Between Modes

From Normal to Bypass Mode. Press any button to activate the menu

options, then select CONTROL and GO TO BYPASS.

From Bypass to Normal Mode. Press any button to activate the menu

options, then select CONTROL and GO TO NORMAL.

Retrieving the Event Log

To retrieve the Event Log through the display:

1. Press any button to activate the menu options, then select

EVENT LOG.

2. Scroll through the listed events.

To retrieve the Event Log through the serial port:

1. From the communication device connected to the serial port, send

one of the following command sequences: ESC-L (ASCII characters

27 and 76) or ESC-I (ASCII characters 27 and 108).

The UPS returns a header containing the UPS identification (UPS

type, part number, and serial number), firmware version, and the

current date and time, followed by the event history.

2. Use the connected communication device to view or print the

information. The report is delivered in ASCII format.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 118 119

Pas de commentaire

Rackmount VA 2000 Guide de l'utilisateur Page 55